I have problem when I want to upgrade and setting my Access Point.
I can't change the Ip address of my AP to access it from web.
Sometimes my computer got bluescreen when I connect with USB serial / console cable.
Help how to change my AP from LWAPP to Autonomous AP and what IOS do I use to this AP.
Ok, do the entire process again. But this time, copy-and-paste the entire process. I want to see what you are doing and where it's failing.
It's really hard to point out to you where the problem is because you are posting screenshots.
When you released the button after 29 seconds, the AP automatically assigns itself a 10.0.0.1 IP address (as per instruction).
Two lines later, the AP tries to search for the file. But look at the line after that. It's a "connection timeout". This basically means the AP could not contact your TFTP server.
Maybe you need to check if Windows FW is enabled.
Check these post, It may helps.
If still getting problem then change the computer or laptop and try with that.
Dont forget to rate helpful posts