10-29-2013 06:10 AM - edited 07-04-2021 01:10 AM
Hi!
I am having a problem where my AP wont join the WLC.
I have solved this problem before by telling the access point where the AP is located. But i cannot remember how the command was.. Anyone have any idea?
/Lajja
Solved! Go to Solution.
10-29-2013 06:13 AM
the command is capwap ap controller IP address
Sent from Cisco Technical Support iPhone App
10-29-2013 06:13 AM
the command is capwap ap controller IP address
Sent from Cisco Technical Support iPhone App
10-29-2013 06:14 AM
Thank you!
10-29-2013 06:15 AM
Make sure the time is set properly on the WLC and the country code for the AP is defined in the WLC. You can also place the ap on the same subnet as the WLC manager and have the ap join the WLC. Then after it joins you can move it to another vlan.
Sent from Cisco Technical Support iPhone App
10-29-2013 06:17 AM
Another command is: test capwap controller IP
Sent from Cisco Technical Support iPhone App
10-29-2013 12:43 PM
Please find the set of useful capwap CLI config guide..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide