Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

problems with a repeater access point

When configuring a repeater access point, the log file displays the following messages:

"associated to parent [aaaa]"

"reassociate response from parent [aaaa]"

several times in a second (never stop), and the following warning message appear:

"failed to send packet on port awc0" (error = 0x00000041)

1 REPLY
New Member

Re: problems with a repeater access point

1 Upgrade firmware on the device to 12.03T

2 Reset the device configuration on the repeater.

( this happens when the configuration file on the AP repeater gets corrupt)

3 Change Ethernet to 100 Bast T Half Duplex.

It will work perfectly fine ..

148
Views
0
Helpful
1
Replies