Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Problems with 'N' on autonomous AP 1142

Hello!

I have 2 autonomous AP 1142.

And i try to make 802.11n connection between them using 2.4GHz interfaces,

setting of ssid of both AP's are the same, WPA2/AES, WMM enabled by default.

Using GUI i can see throughput from 1 to 54 Mbit/s, but it is less then max speed of 802.11n.

Do you know how to solve this problem?

3 REPLIES

Re: Problems with 'N' on autonomous AP 1142

are the "M 0-15" rates enabled?

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Community Member

Re: Problems with 'N' on autonomous AP 1142

Yes, i enabled rates from 1 to 15 Mbit/s.

I'm new in 1142, can i connect 2 autonoumous 1142 AP's using 'N' to test connection between them?

Community Member

Re: Problems with 'N' on autonomous AP 1142

Check on the 802.11a/n settings 11n mode is enabled and that you have the "High Throughput (802.11n) MCS Data Rates enabled 7Mbps thru 144Mbps.

You will not see the higher datarates in the 802.11a/n Network , this only shows Data Rates 6Mbps thru 54Mbps.

Hope this helps

David

829
Views
0
Helpful
3
Replies
CreatePlease to create content