Are you using 5760 with a CA design or is it simply use WLC in CUWN design. If it is a CUWN design, then you need to configure AP connected port to trust DSCP & WLC connected switchport to trust CoS. Then WLAN to be configured with platinum equivalent QoS policy. The first link (witten by Jerome Henry) you found is the one at least explain topic in detail. I haven't configure it by myself, if I get a chance I will test this & let you know.
If you are using this as part of a CA design, then you can classify wireless traffic at access layer same as your wired traffic. Below post will give some guidance & few other reference links if you are in that situation.
Mine is a existing CUWN so I already have QoS to/from Acess point< -> WLC, we only need to apply coresponding policy to the voice ssid.. The first link is seem not correct for 3.3.x code. I should have about 4 policies with planium for voice as planium but it pop up the above error upon configure ....
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...