Per this guide, the answer is yes. The ap would be in bridge mode. You would have to test this out. Doesn't say if it can be a repeater for another vendor ap or not if that is what your trying to accomplish.
The WAP device can act as a single point-to-point mode access point, point-to-multipoint bridge, and as a repeater. In the point-to-point mode, a single WAP device accepts connections from clients and other devices in the network. In a point-to-multipoint bridge mode, a single WAP device behaves as a common link between many access points. WAP device can also act as a repeater, where it can establish a connection between access points which are far apart from each other. Wireless clients can connect to this repeater. A WDS role system can be compared similar to the role of the repeater.
For the configuration guide please refer to the following link-
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...