Ok, ericgarnel that's good. Can you consider that we would like to offer the coverage at the edge points at -85 dbs and 18mb/s data rate using 1141Ap. Combined with the n technology ,how long will the radius of this will be?
I do a couple of things. from experience I try to space ap's about 100 to 150 feet apart in a honecomb configuration. That way I can achieve some level of channel separation. 2.4 GHz is channenging with only 3 channels, but 5.8 can give you anywhere from 11 to 24 (uni 2 extended).
Next thing, there are a couple tools you can use for this. Motorola has a program called Lan Planner or Etnerprise Planner..both do the same as far as designing and running simultations, but Enterprise planner includes the ability to model cellular and you can perform several types of prediction models and see them in 3d as well. They also have a tool for doing mesh and a couple others and a very powerful tool and is not a cheap tool. The other tool you can use is from Airmagnet..they have a wireless planning tool that is similar to enterprise planner exscept you dont get anything other than a heat map simulation. It will do the job if all you are looking for in an inexpensive too. I would also recommend at a minimum the Airmagnet Spectrum Analyzer as well..this will let you see whats in the air because you are bound to run into rogue devices, cordless phones and microwave ovens which will mess with any 2.4 GHz network. As well as seeing whats in the 5.8 spectrum.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...