Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
Hi - I've configured my AP1200 and apparently it works, but just after a few minutes the radio shuts down.
This is what I get in th elog - any ideas? Thanks.
Mar 1 00:18:01.459
Interface Dot11Radio0, no valid power levels available
Mar 1 00:17:48.839
Task is running for (5994)msecs, more than (2000)msecs (1/0),process = Dot11 driver.
Mar 1 00:17:46.840
Task is running for (3995)msecs, more than (2000)msecs (1/0),process = Dot11 driver.
Mar 1 00:17:44.841
Task is running for (1996)msecs, more than (2000)msecs (1/0),process = Dot11 driver.
Mar 1 00:17:42.841
Interface Dot11Radio0, Radio boot strap failed, Trying hardware reset on radio
Mar 1 00:17:32.781
Line protocol on Interface Dot11Radio0, changed state to down
Mar 1 00:17:31.782
Interface Dot11Radio0, changed state to reset
Mar 1 00:17:31.781
Interface Dot11Radio0, changed state to down
Interface Dot11Radio0, Deauthenticating Station 5046.5d1e.5505 Reason: Previous authentication no longer valid
Mar 1 00:17:31.779
Interface Dot11Radio0, failed - Radio command failed, cmd 230 (0,0,0) status 7F30 (0,0,0)
Looks like some sort of firmware issue. Try to upgrade the AP software & see if that fix this.
**** Pls rate all useful responses ****