This might be a stupid question: I have 7 AIR-LAP 1231G-A-K9 APs: I have two of them up and working and the other 5 turned off: The vendor (before I was here) had a answer to every problem: add more APs. I know it's hard to believe. The WLC shows the five APs (Admin Status: disabled and Opertional Status disabled)I'm still recieving interference on the other two live AP's. The question: Could the five APs that are disabled still cause interference?
Reasons for the occurrence of CRC errors: 1) Packet collisions that occur due to a dense population of client adapters 2) Overlapping access point coverage on a channel 3) High multipath conditions due to bounced signals 4) Presence of other 2.4-GHz signals from devices like microwave ovens and wireless handset phones. I don't think it is #1 I have very few clients and they not on the network all at once. It could be overlapping: although half of the APs are turn off. It could be mulitpath/bounced signals. This is a paper mill I'm working in, so I have huge Paper making machines (21/2 stories tall and half foot ball field long) and it could be wireless handsets (forklift drivers have cell phones) The other caviats are I'm getting the same CRC errors in warehouses where there are no machines and or forklifts operating. The APs are showing the same 60% error rates no matter what building they are in. I'm unable to find a location where the APs show a different CRC error. I'm rambling on but I'm not sure where to go next.
Since you mentioned it's a paper mill and you do have tall equipment, I don't see how two APs can provide good coverage. What is the power level on the 2.4? Is your 2.4ghz data rates (802.11b) all set to mandatory? Im guessing you might be seeing crc errors because of the poor signal and snr.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...