Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Radius Authentication

Dear's

        Anybody can help to configure radius authentication on 1140 Access Point.  Is it possible to integrate with Radius 2003 server.

i am facing problem for authentication and getting this error on radius server.

User test was granted access.
Fully-Qualified-User-Name = <undetermined>
NAS-IP-Address = 10.1.5.7
NAS-Identifier = ap
Client-Friendly-Name = access point
Client-IP-Address = 10.1.5.7
Calling-Station-Identifier = 0021.0063.fb97
NAS-Port-Type = Wireless - IEEE 802.11
NAS-Port = 341
Proxy-Policy-Name = Use Windows authentication for all users
Authentication-Provider = <none>
Authentication-Server = <undetermined>
Policy-Name = <undetermined>
Authentication-Type = <undetermined>
EAP-Type = <undetermined>

For more information, see Help and Support Center at

___________________________________-

An Access-Request message was received from RADIUS client access point with a message authenticator attribute that is not valid.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.

_____________________________________________

anybody help to configure radius authentication on cisco 1140 access point.

253
Views
0
Helpful
0
Replies
CreatePlease to create content