Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Re-association Problem

Hi,


Currently we are using Cisco Thin-client wireless APs.  When roaming from one AP to another sometimes there are connection problems.  Below is an example.

I was using my laptop associating with AP1.  When I moved my location to another area – AP2, I still can have the connection.  However, when I moved back to AP1, I could not get connectivity.  When I went back to AP2, AP3 or AP4, I was able to get connected.  My laptop just could not get anything from AP1 only.  Until AP1 is reset, then my laptop could get connected.

Not too sure where i can start troubleshooting from.

regards

1 REPLY
Hall of Fame Super Gold

Re: Re-association Problem

Thin client?  You mean LWAP?  IF LWAP can you post your firmware?

If not, can you elaborate a little bit further?  What model of APs and their firmware?  Can you post the config of AP1?

Is this affecting all clients or just a few?

187
Views
0
Helpful
1
Replies