Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rebooting the second ctl in a wism (6509 )

Is there a way to just reboot the second ctl on a WISM.. WS-SVC-WISM-1-K9

console cable and session commandare both not an option. both are dead. . thought I can try " hw-module subslot 9/2 reload " that didn't work either.. 9 being the slot number and 2 being the second controller.

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: rebooting the second ctl in a wism (6509 )

From the sup720 the hw-mod command is your only option.  This will reboot both controllers.  There isn't a way to reboot only one of the controllers in the blade without getting into the controller.

3 REPLIES
Gold

Re: rebooting the second ctl in a wism (6509 )

From the sup720 the hw-mod command is your only option.  This will reboot both controllers.  There isn't a way to reboot only one of the controllers in the blade without getting into the controller.

New Member

Re: rebooting the second ctl in a wism (6509 )

Thanks, Not the answer I was looking for ! :-)

Hall of Fame Super Gold

Re: rebooting the second ctl in a wism (6509 )

You can also turn the power off of the slot.

1963
Views
0
Helpful
3
Replies