We currently run approx. 200 1142 AP’s managed by a couple of WLC’s (version 6). These are all in internal locations. We would now like to cover external areas and are looking for a simple external AP to deploy, ideally the AP will support 802.11 a,g,n. The external areas are the open spaces between campus buildings
We don’t want anything too fancy i.e. we don’t need CleanAir technology or 3G/4G offload.
How large of an area are you looking to cover? If you're just looking to cover a samll area right off of the building you could look into the 1310, which on the WLC acts as an AP, but it's outdoor rated.
If you need to cover a large area, like the parking lots, you may need to look into the 1552 AP.
Downside to the 1310, is it's only 2.4 b/g, the 1552 is a/b/g/n.
Alternately you could use the 1262 with some LMR to extend the antenna outside the building, again this would be for an area near the building.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...