Recover from flashing wrong firmware version on Aironet 1200 AP
I was a little too quick on the gun yesterday and updated the wrong firmware file [c1200-rcvk9w8-tar.123-7.jx.tar] instead of the right one [c1200-k9w7-tar.123.7.ja2.tar] using the browser to my AP1200.
Now, the ap boots up, but gives me an error on the fastethernet port and reboots. I get a few seconds in the ios before each reboot, but that is it. is there any way to stop the boot process and send the right firware to it through the serial link? Thanks.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...