I have an 1200 series AP, and when i try to associate it as a repeater, it associate and disassociate many times per second, and after a while, it gets blocked or shuts down. I have configured the same authentication type for both (root and repeater) and identical configurations for radio parameters.
I have tried with another device (another repeater access point) and still doesnt work
There could be something stuck in the access points configuration that is causing the problem. Try resetting the access point back to factory defaults and reconfigure the unit. You may need to reset the access point that it is trying to associate to as well.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...