Well you would need to convert an access point to a repeater and then setup that autonomous AP as a repeater. Now as this will work, it might not perform as good as you want it to, so you will just have to test it and see for yourself.
Also depending on the floor, if its line of sight, you can maybe use a 3602e and use a patch antenna to shoot the signal further down. You would need good line of sight also for a repeater or else the backhaul will have a poor connection speed.
Help out other by using the rating system and marking answered questions as "Answered"
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...