Hello,
I am planning to install a Wireless Integrated Service module WS-SVC-WISM-1-K9 card in slot 12 of a WS-C6513, the model will be brand new, so I can still choose what version to run on it. Does anyone knows about problem/limitation for such a deployment, can you please point me where to check such details...If somebody is actually running a similar card over this plattform I am keen to find out issues, possible nessary upgrades to the current IOS etc...
Many thanks in advance...
Below is the information from my 6513 switch.
System image file is "sup-bootflash:s72033-jk9sv-mz.122-17a.SX3.bin"
cisco WS-C6513 (R7000) processor (revision 1.0) with 458752K/65536K bytes of memory.
Processor board ID.........
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
14 Virtual Ethernet/IEEE 802.3 interface(s)
316 Gigabit Ethernet/IEEE 802.3 interface(s)
1917K bytes of non-volatile configuration memory.
8192K bytes of packet buffer memory.
65536K bytes of Flash internal SIMM (Sector size 512K).
Standby is up
Standby has 458752K/65536K bytes of memory.
Configuration register is 0x2102
1 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
2 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
3 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
4 16 SFM-capable 16 port 1000mb GBIC WS-X6516A-GBIC
5 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
6 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
7 2 Supervisor Engine 720 (Active) WS-SUP720-BASE
8 2 Supervisor Engine 720 (Hot) WS-SUP720-BASE
9 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX
12-----Plan to use for the WS-SVC-WISM-1-K9
Please feel free to ask me for
Thanks in advance..