Requirements to install a WS-SVC-WISM-1-K9 card in WS-C6513 running WS-SUP720-BASE
I am planning to install a Wireless Integrated Service module WS-SVC-WISM-1-K9 card in slot 12 of a WS-C6513, the model will be brand new, so I can still choose what version to run on it. Does anyone knows about problem/limitation for such a deployment, can you please point me where to check such details...If somebody is actually running a similar card over this plattform I am keen to find out issues, possible nessary upgrades to the current IOS etc...
Many thanks in advance...
Below is the information from my 6513 switch.
System image file is "sup-bootflash:s72033-jk9sv-mz.122-17a.SX3.bin" cisco WS-C6513 (R7000) processor (revision 1.0) with 458752K/65536K bytes of memory. Processor board ID.........
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache Last reset from power-on Bridging software. X.25 software, Version 3.0.0. SuperLAT software (copyright 1990 by Meridian Technology Corp). TN3270 Emulation software. 14 Virtual Ethernet/IEEE 802.3 interface(s) 316 Gigabit Ethernet/IEEE 802.3 interface(s) 1917K bytes of non-volatile configuration memory. 8192K bytes of packet buffer memory.
65536K bytes of Flash internal SIMM (Sector size 512K). Standby is up Standby has 458752K/65536K bytes of memory.
Configuration register is 0x2102
1 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
2 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX 3 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX 4 16 SFM-capable 16 port 1000mb GBIC WS-X6516A-GBIC
5 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX 6 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...