If you enter the clear lwapp private-config command, you might see this error message:
AP0017.5922.f384#clear lwapp private-config
ERROR!!! Command is disabled.
This error message indicates that the static configuration commands are locked out because either:
This command was entered while the LAP is registered to a controller.
***The LAP was previously registered to a WLC, but the username/password was not changed from the default
So try this;
Once your LAP successfully registers with the WLC, the static LWAPP configuration commands (discussed in the previous section) are locked out and are no longer accessible. In order to re-enable the commands, you must have set the username and password while the LAP was joined to the previous controller.
When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:
Thanks for your response. Unfortunately, the lwapp refuses to register with the controller properly, which is why I want to wipe it to factory defaults.
I can nuke the private config using the mode-button bypass.
When the AP tries to associate with the controller, it downloads the firmware and then disasociates with the controller immediately after the download. That means, of course, I can't enter the commands via the controller, but I can't use the lwapp commands on the AP either (becuase it thinks its registered).
I had the same errors when I was using Outdoor mesh 1522 and 1131AG both got solved different ways.
1131AG. Unplug the NIC cable and power cable. Press the reset button and reboot. Letgo the reset button. If u got prompted before the full boot... type boot and it will complete the boot. Then try the clear privtae...command.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...