Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Reset WLC Module to factory defaults from router cli

I have a wireless lan controller module in a 2811 router that has a previous config and need to reset it to factory defaults from the router cli.  Every time I try a "service-module wlan-controller 1/0 reset" I don't see any output on the screen indicating the boot process that would allow me to interrupt it and reset a password.

I tried following this doc but had no luck:

https://supportforums.cisco.com/docs/DOC-3668

Anyone have any experience with this?

1 REPLY
Hall of Fame Super Red

Re: Reset WLC Module to factory defaults from router cli

Hi Joe,

Not sure, but this doc does list a couple of different steps

http://www.cisco.com/en/US/products/ps6308/products_password_recovery09186a008071faa7.shtml#topic1

Cheers!

Rob

779
Views
0
Helpful
1
Replies
CreatePlease to create content