Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Resetting 1242AP to default using the MODE button

I have a couple of remote 1242APs with static IPs that are not responding to pings. I'd like to reset the APs and see if they will pull DHCP addresses. If we reset the APs using the mode button will with wipe out the static IP?

Thanks!

Everyone's tags (1)
3 REPLIES
Hall of Fame Super Red

Resetting 1242AP to default using the MODE button

Hi Jason,

Yes, the IP will be reset to 10.0.0.1

Cheers!

Rob

Silver

Resetting 1242AP to default using the MODE button

its no, You have to configure from console only

---

Posted by WebUser Srinivasa Reddy

New Member

Resetting 1242AP to default using the MODE button

HI Jason ,

If you use the mode button it will reset the entire configuration and make the AP to Factory default. If you have DHCp enable in your network AP will be taking DHCP IPaddres .

As far as i know the default ip 10.0.0.1 will come only if you are going to the AP rommon mode ( for recovery )

Regards

Angus

Please rate the post if its usefull .

1089
Views
0
Helpful
3
Replies
CreatePlease to create content