Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Resetting a AIR-LAP1252AG back to factory defaults

The AP (AIR-LAP1252AG-A-K9) was originally configured using telnet and then the controller. We moved it to a new location with the idea of changing the IP when we got it to the new location. We were unable to get it to work at the new location and thought we would reset it to default and start from scratch. We couldn't reset it by restarting and pressing the mode button. I brought it back to the original location and cannot see it from the controller when I do a MAC search and still can't reset it.

2 REPLIES
Hall of Fame Super Gold

Re: Resetting a AIR-LAP1252AG back to factory defaults

You need to let the LAP join the WLC and enable the Mode button.

Go to the CLI of the WLC and type in the following command to convert it back to Autonomous IOS:

config ap tftp-downgrade

To enable the Mode/Reset button, the command is:

config ap rst-button enable

Hope this helps.

Hall of Fame Super Silver

Re: Resetting a AIR-LAP1252AG back to factory defaults

Console into the LAP and power cycle the unit. Post the output so we can see what is happening.

-Scott
*** Please rate helpful posts ***
3065
Views
0
Helpful
2
Replies
CreatePlease to create content