When in standalone we just need to make sure that all the access points have the same SSID configured and the same security method, and that each AP is using the non overlapping channels on the 2.4 GHz.
Also that the APs have been located on site where the overlap between each AP coverage cell is not more than 15%.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...