I am a beginner and am setting up a simple wireless network at home with a 1941 router and AP1142N. the router is config with 192.168.1.1 at the G0/1 interface and the LAP is config with 192.168.1.2 at the gigbit port. Both are connected to a procurve switch. there may be 6 or 7 wireless clients at max activity - mainly iphones and laptops.
what is best practice for the router config? should the G0/1 be set as a virtual bridge. should the LAP provide IP addresses to the clients, or should this be handled by the router? I have been looking for a beginners guide on theory, but have not found much. Any advice appreciated. Thanks
What is providing dhcp for the wired side? That is what I would use. Usually I would use a dhcp server, then my next choice would be the router then the ap. Also the port the ap is connected to should either be an access port or a trunk port if you need to pass more than on vlans.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...