I am using WLC 2504 with AP1242 to access LAN through wi-fi and below are the details/configuration i am using.
1. Using a belkin router with LAN IP 220.127.116.11 and DHCP 192.168.6.1
2. Connected WLC 2504 with belkin router [192.168.6.254] and enabled DHCP [192.168.6.200-250] on WLC 2504 for Access points.
3. All these devices [Belkin router, WLC 2504 and APs ] are connected on 8 port unmanaged switch.
wi-fi connectivity is working fine and we are able to access 192.16.17.X series from wi-fi [192.168.6.X] but can not access 192.16.17.X from wi-fi 192.168.6.X so is there any way to access wi-fi IP series 192.168.6.X from LAN 192.16.17.X.
Please share the information if anybody has the information.
If you have different subnets defined on the 2504, then you need a managed switch that allows the port to be trunked. The WLC 2504 does not route and that is why. The WLC only bridges the traffic in which your switch has to pass the vlan tag and your router has to route the vlans. I don't think your home router can route multiple inside networks and your un managed switch for sure will not pass vlan tag.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...