I recently deployed a SAP702i in a branch office and I came into the office today to find that the AP was not passing Internet traffic but I could access local resource through it. All wired machines were working fine and no complaints from users but I had to reboot the AP to get the wireless working properly again. I looked at the logs and saw that the line protocol went down on the dot11radio's a few times but nothing else. Any advice on where to start looking?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...