I'm new to Cisco AP's. I'm trying to setup security per VLAN on a new 1130ag.
I finally got the Guest VLAN configured for Open Authentication (I'll lock down VLAN access after I get AP setup, it's not live yet). Where is the option to broadcast SSID for this Guest access? I have to manually enter in the network...
But more importantly, I'm trying to setup an INT VLAN on the AP with security enabled. Looking through the SSID Management section, here is what I have:
INT should be the SSID name, and I'm wanting to broadcast this, but like the Guest VLAN, it's not showing up.
Open Auth no addition
Key Mngmnt Mandatory
enable WPA WPAv2
WPA pre-shared key: cisco ASCII
These are the options I've enabled in hopes of requiring a client to type "cisco" to connect, and have WPA2 for encryption.
Am I doing something wrong? I manually enter the INT for the wireless network and get "Connection timed out", but am able to connect to the Open 'Guest' network.
And again, I see the "Broadcast SSID" in the Quick Security Setup option, but not in the SSID Management section.
Thanks for reading. And thanks for any advice/tips.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...