Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Security processing of Image Data failed from AP

I have a new WLC2006 and new 1131AG access points. The access points reboot over and over again and the controller log shows:

Security processing of Image Data failed from AP xx:xx:xx:xx:xx and an error about /bsn/ap/1130c not being found. Thanks for any help.

4 REPLIES
New Member

Re: Security processing of Image Data failed from AP

Hi Matthias,

I experienced a similar problem too but with 1100 Access points.The controller runs 2.2.X.X firmware and i tried to upgrade it to 3.2, but get an error "Insufficient Flash Memory" after tftp files are downloaded.the controller works fine with Internal DHCP enabled.

Thanks and Regards,

Mohan

New Member

Re: Security processing of Image Data failed from AP

I just go off the phone with TAC and they sent me the most recent firmware and that fixed my problem for me. Thanks for your response though.

New Member

Re: Security processing of Image Data failed from AP

Many thanks for your quick reply!!would like to know how to upgrade the controller from the existing 2.2.X.X to the latest 3.2.X.X. Get an error "Ïnsufficient Flash Memory"after downloading the latest code.

Thanks and Regards,

Mohan

New Member

Re: Security processing of Image Data failed from AP

I didn't get the insufficient memory error. I was running 3.2.78 before updating, so . . .

I hope someone can help you though. I am very new at this.

280
Views
0
Helpful
4
Replies