Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Set AP as client

Hi to all,

Can I set an AP (1200 o 1300 series) as client?

My problem is that I have to connect a video network camera to a WLAN but I cannot configure it as bridge. So I ask can I associate a AP as client to WLAN and then connect to eth of AP the netcamera?

Linksys do that with WET54G, but is linksys I prefer use Cisco!

Thanks a lot.

Augusto

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Set AP as client

You would need to configure the AP as a WGB or Universal WGB. this will allow the AP to associate to the network, and have a client out the ethernet.

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43hot.html#wp1041408

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
1 REPLY

Re: Set AP as client

You would need to configure the AP as a WGB or Universal WGB. this will allow the AP to associate to the network, and have a client out the ethernet.

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43hot.html#wp1041408

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
154
Views
0
Helpful
1
Replies
CreatePlease to create content