I have a Cisco Aironet 1131ag I bought to play with to learn the wireless side of cisco. I am having issues using the web interface, it doesn't ever seem to apply my settings and is very slow.
On the command line I need a little help. I am used to it using switches and routers however.
I was hoping someone could get me started. Here is what I am trying to achieve
basic stand alone setup of this ap
static ip set (do I want to assign one to each of the radios, i see it also has a bridge interface. do I want my main ip to be the fastethernet0 interface?)
setup the ssid's and enable the radios
setup wpa2 key for the security for each of the radios
setup dhcp relay to my switch handing out IPs
setting up the SSID's to the correct vlan.
If someone just has a config they have using it as a stand alone that should be all I need to get started.
Thanks for the help
Here is my current config
ap#show running-config Building configuration...
Current configuration : 1555 bytes ! version 12.4 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname ap ! no logging console enable secret 5 $1$t2sx$WwFrFGRmFhkKyYbm7tMTD0 ! no aaa new-model ! resource policy ! ip subnet-zero ! ! ! dot11 ssid Test ! power inline negotiation prestandard source ! ! username Cisco password 7 1531021F0725 ! bridge irb ! ! interface Dot11Radio0 no ip address ip helper-address 10.1.1.115 ip security dedicated unclassified genser ip security add no ip route-cache ! ssid Test ! station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled ! interface Dot11Radio1 no ip address no ip route-cache shutdown dfs band 3 block channel dfs station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled ! interface FastEthernet0 ip address 10.1.1.249 255.255.255.0 no ip route-cache duplex auto speed auto bridge-group 1 no bridge-group 1 source-learning bridge-group 1 spanning-disabled ! interface BVI1 ip address dhcp client-id FastEthernet0 no ip route-cache ! ip http server no ip http secure-server ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag bridge 1 route ip ! ! ! line con 0 line vty 0 4 login local ! end
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...