cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1283
Views
5
Helpful
3
Replies

Show Commands in 1131 AG AP

johnlloyd_13
Level 9
Level 9

hi experts,

i would like to know how to verify using show commands in CLI if 1131AG AP radio is working and if clients are associating on AP

3 Replies 3

Rob Huffman
Hall of Fame
Hall of Fame

Hi John,

show dot11 associations

[client | repeater | statistics | H.H.H | bss-only | all-client | cckm-statistics]

This example shows how to display all client devices associated with the access point:

AP# show dot11 associations client

show controllers dot11radio

Use the show controllers dot11radio privileged EXEC command to display the radio controller status.

show controllers dot11radio interface-number

Syntax Description

interface-number

Specifies the radio interface number. The 2.4-GHz radio is radio 0. The 5-GHz radio is radio 1.

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_2_JA/command/reference/cr32main.html#wp2141071

Hope this helps!

Rob

Leo Laohoo
Hall of Fame
Hall of Fame

In addtion to Rob's post (+5), I would also add show dot11 associations stat. This will give you a reading of the number of successful authentication since last counter reset (by reboot). I look at the values of cDot11AssStatsAuthenticated.

Hope this helps.

thanks for the inputs!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: