Show Commands in 1131 AG AP

[johnlloyd_13]

hi experts,

i would like to know how to verify using show commands in CLI if 1131AG AP radio is working and if clients are associating on AP

[Rob Huffman]

Hi John,

show dot11 associations

[client | repeater | statistics | H.H.H | bss-only | all-client | cckm-statistics]

This example shows how to display all client devices associated with the access point:

AP# show dot11 associations client

show controllers dot11radio

Use the show controllers dot11radio privileged EXEC command to display the radio controller status.

show controllers dot11radio interface-number

Syntax Description

interface-number

Specifies the radio interface number. The 2.4-GHz radio is radio 0. The 5-GHz radio is radio 1.

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_2_JA/command/reference/cr32main.html#wp2141071

Hope this helps!

Rob

[Leo Laohoo]

In addtion to Rob's post (+5), I would also add show dot11 associations stat. This will give you a reading of the number of successful authentication since last counter reset (by reboot). I look at the values of cDot11AssStatsAuthenticated.

Hope this helps.

[johnlloyd_13]

thanks for the inputs!