In short, it is preferred to have users connect to access points.... 99% of the time. You can use a wireless bridge (that is associated to an AP) that is connected to a switch/hub to supply network connectivity to wired users off the switch/hub. There are also access points that can be used as a bridge for building point to point connectivity.
Look at the home users with wireless.... it allows then to move from place to place (as long as there is coverage) without having to be wired in.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...