I have a simple multicast setup that I can't get working. I have a Cisco WLC 2504 on version 7.4.110 (tried with 7.4.100) with one AP connected (3502). I have two SSIDs (psk limitation on apple tv) that point to the same interface with a default mdns profile attached to it. What I can not understand is why my airplay icon wont light up on my mac osx. When I connect through my corporate network (embedded LWAP on an dmvpn spoke) I can see my corporate apple tv just fine.
I ran a packet capture and debug mdns all and I see the reply with my apple-tv sent back to the my laptop, both mdns replys look fine for the apple tv service. I am a little confused at to what is the issue. The clients default gateway for both the macbook point the svi on my vlan, and just for grins I have ip pim sparse-dense mode configured.
I also tested with an ipad and i get the same results.
The corporate controller I tie back into is a 5508 that is on version 7.4.100
If there are any debugs I can provide let me know, I can clean the screenshots if anyone wants to see the packet capture. I wanted to ask to see if there is a simple setting I may be missing.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...