I know how to use the SNMP tools and MIB walks to get info from APs. But what I don't understand is to drill in and get SNMP information from a particular AP when I walk a controller. As an example, here's some SNMP MIBs from a recent walk:
There appears to be additional digits added to each OID to make each a unique value. Since I used an SNMP walk to obtain this information, how would I go about getting the information for a particular AP without knowing this information in advance? Do I have to SNMP walk the AP directly?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...