Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP operation to Device failed: Attempt to set conflicting attribute value

after upgrading the firmware on the wireless lan controller 5.2.178.0 on my cisco 4402 wlc's and rebooted the devices, I am getting matches on the audit status between whats on the contoller and the wcs software. so i am trying to apply whats in the wcs templates created for the controller and i am getting this error.

SNMP operation to Device failed:                                  Attempt to set conflicting attribute value

I am thinking that i need to rebooted the wlc's again because from the error it sounds like the values that i am trying to write to the controllers are already present

anyone ever seen this error?

thanks.

1 REPLY

SNMP operation to Device failed: Attempt to set conflicting attr

Justin,

   If the controllers are workign properly and everything seems good, then the first thing I would do is update the WCS configuration from the controllers doing then do an audit compare again..  I have also seen this issue is you have alot of AP groups or H-reap groups.

Hope this helps.

2002
Views
0
Helpful
1
Replies
CreatePlease login to create content