Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SSID dedicately for 802.11n

Hi,

 

How to enable a SSID delicately for 802.11n?.

802.11a/802.11b/802.11g should not be allowed.

 

thanks,

Ramesh

  • Getting Started with Wireless
Everyone's tags (2)
3 REPLIES
Gold

Hi Ramesh,Unfortunately this

Hi Ramesh,

Unfortunately this is not possible. You could do is try disabling low MCS data rates but you need to have at least one legacy rate enabled. The best bet you can have is to enable rates 54Mbs and above. 

Hope that helps.

Regards

Najaf

This is not possible with 

This is not possible with  the wireless standards version.

VIP Purple

Hi Ram,802.11n cant work

Hi Ram,

802.11n cant work alone, it runs on either 802.11g or 802.11a. If you have the 802.11N supported APs and then if you have enabled N on the WLC global, then you wil get N speeds if you have configured the clients for either

Open Auth + no encryptions + all MCS rates enabled + WMM enabled

OR

WPA2 (PSK/Enterprise) + AES encryption only + all MCS rates enabled + WMM enabled

 

Regards

Dont forget to rate helpful posts

199
Views
5
Helpful
3
Replies
This widget could not be displayed.