I have an standalone ap but it is not work on the dhcp for wireless connection with the below config, but when i plug in the ethernet cable to the that is able to get the ip address, i have try to config related ip to do.1 or f0.1 or bvi1 but still not working.
Is it not possible to have a dhcp function on standalone ap?
Current configuration : 3015 bytes
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
logging rate-limit console 9
enable secret 5 $1$oJyM$DPgTtPIB82lhgm2bUP9b90
no aaa new-model
no ip dhcp use vrf connected
no ip dhcp conflict logging
ip dhcp excluded-address 10.18.20.1 10.18.20.200
ip dhcp excluded-address 10.18.20.203 10.18.20.254
ip dhcp excluded-address 192.168.0.1 192.168.0.200
ip dhcp excluded-address 192.168.0.203 192.168.0.254
During the test, i got two SSID but i am not able to get the ip address through wireless but when i plug a computer to the ethernet port the ap it can get the ip address. Is there anything i miss in the configuration.
I find that this ap is set as
I find that some of the suggest is config tas non-root bridge but i it don't have this option, is it the way cause the dhcp fail?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...