The WLC is running the software version 5.2.193, which support the 1524 LAPs. I enter the MAC Address in the MAC Address Filter. I connect the LAP to switch and this LAP was registered in the WLC. In the configuracion of the LAP I set the "AP Role" to RootAP, and the field "Bridge Group Name" was completed with a specific name. Then, I connect a second LAP to Switch, the LAP was registered in the WLC. The setting applied to second lap, was, "AP Role" to MeshAP and the field "Bridge Group Name" was completed with the same specific name, entered in the RootAP. Then, I save the configuration, and disconnect the MeshAP but the mesh is not established. Am I missing some configuration?
WLC Model : AIR-WLC2106-K9 AP Model: AIR-LAP1524PS-A-K9
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...