Just to add, it's the WLC code version that determines the support for access points not really the WLC model. This is because depending on what code you have on the 5508, the 5508 can support the 1600's only if on v7.4.x. If you had v7.0.x, then the 1600's would not be supported. So take a look at the matrix that Sandeep posted and also reference the guides for code version and the ap release notes which will tell you what code the WLC will also need to be on.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...