Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

switchport setup for lwapp access point running several ssid's

Hi all

when setting up an lwapp acces point, do I need to trunk all the vlans on the port to the ap? or do I only need to enable the management vlan to the acces point ? ie 1 vlan and normal access port ?

cheers

Carl

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: switchport setup for lwapp access point running several ssid

If its a LWAPP AP, then the switchport should be a ACCESS PORT.. this is just to get the IP address to the AP, then the AP wil try to join the WLC.. once the AP joins, the SSID and rest flow through the LWAPP tunnel..

Regards

Surendra

2 REPLIES
Cisco Employee

Re: switchport setup for lwapp access point running several ssid

If its a LWAPP AP, then the switchport should be a ACCESS PORT.. this is just to get the IP address to the AP, then the AP wil try to join the WLC.. once the AP joins, the SSID and rest flow through the LWAPP tunnel..

Regards

Surendra

Re: switchport setup for lwapp access point running several ssid

Unless you are doing HREAP with more then 1 SSID. Then it would be a trunk ...

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
587
Views
5
Helpful
2
Replies