Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Talk to workgroup bridge via AP?

I have an Aironet 350 access point and also a workgroup bridge. I can ping & communicate with the workgroup bridge's ip address for setup & diagnostics from the bridge's ethernet side, but I cannot see it from the wireless side, i.e., through the AP! I can see all the clients I put on the bridge through the AP, so I know both units are communicating with each other. Does anyone know how to talk to the bridge from the AP side?

3 REPLIES

Re: Talk to workgroup bridge via AP?

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Community Member

Re: Talk to workgroup bridge via AP?

We had the same problem and it turned out that the gateway was not configured. You may want to check your tcp/ip settings. This allowed us to get to the web settings for the workgroup bridge from the AP side which was on a different vlan.

Community Member

Re: Talk to workgroup bridge via AP?

Just solved this situation with AP & WGB 340 by upgrading firmware. Working fine now. Was major pain.

Regards,

Jeff

309
Views
0
Helpful
3
Replies
CreatePlease to create content