Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TPC Set to Zero by Default?

I'm running 6.0.188.0 on a 4402-25 controller, with RMM off.  I have set the TPC at a fixed value of '1'.  However, new APs that land on the controller show up with a power level of 0, with the asterisk indicating that this is the global setting.  I still have to check if WCS is configured differently, but the local config on the controller would/should override WCS.  Any thoughts?

Regards,
Scott

229
Views
0
Helpful
0
Replies
CreatePlease to create content