Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

traffic not crossing a 2006 controller

we configured a 1242 AP with a static IP that's on the same subnet as the rest of our network. we were able to finish configuring the AP-SSID, etc via web-ing into the AP when it was plugged into a network switch. We then powered it off and took it to its permanent location and connected it to a 2006 controller. Now we are unable to see the AP from the network side of the controller. We are getting a signal from the AP but unable to see the AP via GUI, etc. since we are not getting a DHCP IP.

Any Ideas?

1 REPLY
Silver

Re: traffic not crossing a 2006 controller

Sometime DHCP request message is filtered by CHADDR field .Create and enable a DHCP scope on the internal DHCP server so that this can be overcome.Refer URL for more inforamtion on SCOPE

http://cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml#c2

126
Views
0
Helpful
1
Replies