Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunk between Catalyst6500 and AP350

Some questions about the trunk between switchport and an AP350:

how to configure the trunk between Cat6500 an AP350 (is set trunk 4/19 on

dot1q in conjunction with clear trunk and enable trunk at the AP enough)?

which VlanID is the fec0 Interface associated to (the native Vlan)???

Vlan ID must be in the range of 1-16 or can i use for example VlanID 10, 30, 241 (and of course less then 16)???

are there advanced troubleshooting cmdline tools available for AP350?

sometimes i've get a number of errors at the AP when i've changed the native VLAN:

0xd8bb70 (tRcv_fec0):

*** devEthernetEND_c::RecvFrameList: Corrupt 802.3 header (payloadLen 46,

encoded as 64) -- processing anyway!

Cisco Employee

Re: Trunk between Catalyst6500 and AP350

Please go through above url , AP only supports 802.1q trunking .

Above url shows how to enable trunking on AP .

make sure you have same native vlan on AP and on switch

New Member

Re: Trunk between Catalyst6500 and AP350

Hi Nilesh,

i think there are some answers to my questions.

thank you

CreatePlease login to create content