Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Trying to convert a bridging 1250AP to IP routing for LAP

I can't seem to turn off bridging or find a config for an autonomous 1250 with IP routing. I'm trying to convert it to lightweight, but without IP routing it's making it difficult to download the image from a TFTP server.

4 REPLIES
Silver

Re: Trying to convert a bridging 1250AP to IP routing for LAP

Cisco APs are not layer 3 devices. There is no router mode.

With that said, I can't see why you would need to route on the AP to get basic IP connectivity working. Set an appropriate IP address on the BVI1 interface, assign a default gateway, and you're done. What problems are you running into?

New Member

Re: Trying to convert a bridging 1250AP to IP routing for LAP

Thank you for your input, I appreciate it. When I try to ping the default gateway, it says that protocol is not supported.

Silver

Re: Trying to convert a bridging 1250AP to IP routing for LAP

That's one I've never encountered. Can you post your config?

New Member

Re: Trying to convert a bridging 1250AP to IP routing for LAP

131
Views
0
Helpful
4
Replies
CreatePlease to create content