We have a Cisco UC540 with wireless. I would like add another SMB wireless access point to further the reach of the access point footprint. If I add another wireless access point will it work parallel with the built in wireless?
I want to ensure that the wireless is flat and users don't lose connectivity or IP changes while they walk around in the office because they will have wireless handsets (7925) with them.
Do I have to get a LAN controller if I just want to add 1 wireless access point?
I want to make sure that both the built in wireless and the additional wireless work like 1 wireless with 1 SSID. Please advice. Thank you
While UC540 is 'Voice Systems' device and you wish to connect 7925 handsets (those are IP Telephony devices), the matter of the question is - two wireless APs covering the area. Moreover, I assume the second AP will not be the UCxxx kind.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...