Im assuming you have static IP address on the APs, AND the management IP address of the AP is on the same subnet as your WLC
1. Check if your AP is using an LWAPP image -The best way to check is to simply do 'show capwap ip config' if it accepts that command then your AP is for sure using LWAPP
2. Verify if the port on the switch has good connectivity -First, remove the AP connection to the switch, assign your laptop for example the same ip address, connect your computer to the SAME port on the switch, then ping the IP address of the WLC
If you can ping that, then awesome
2. Verify if you still have enough licenses on your WLC -It is actually can be found on the dashboard, but for further details go to:
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...