07-10-2008 09:28 PM - edited 07-03-2021 04:09 PM
Hi,
Having problems using the Web GUI on a c1131AG LWAPP Access Point. Every time I attempt to connect, the AP returns a TCP RST (reset) to the initial TCP SYN request. This is the same for both http & https.
Have check various browers (IE/Firefox etc) and allow "pop-ups".
Can connect into the WiSM GUI - no prblems, just no luck with the APs - which can be controlled by the WiSM GUI etc.
Is there something really basic I'm missing here???
Does the AP need to enable web access?
Any hints would be appreciated.
Thanks
Andrew
07-11-2008 01:24 AM
The last time I checked - you cannot manage a LWAPP enabled AP from a GUI. It must be done via the WLC. You can manage an AP when it's in autonomous mode from a web GUI.
HTH.
07-11-2008 02:47 PM
Thanks - that makes sense and I was starting to think along those lines, just couldn't find any Cisco doco that stated that fact - seems all the c1130 AP doco I read must referred to autonomous mode APs.
Cheers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide