Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

unable to session into wireless controller on 3750G

I am installing a 3750G with the integrated wireless controller for a customer and I am unable to session into the wireless controller from the command line of the switch. I receive the following message:

Sorry, telnet is not allowed on this port!

The switch is is running 12.2(35)SE5 and is part of a switch stack with a 3750G-12S. The 3750G-12S is the master of the stack. I am issuing the following command:

session 1 processor 1

Then I get the error message. Any ideas?

Thanks!

4 REPLIES
Hall of Fame Super Silver

Re: unable to session into wireless controller on 3750G

Did you configure the WLC and enable telnet?

-Scott
*** Please rate helpful posts ***
New Member

Re: unable to session into wireless controller on 3750G

Hmmm... I was trying to access the controller via the telnet session in order to do just that. Perhaps it is a cart before the horse scenario. I can get in on the console.. I'll do it that way. Thanks.

Hall of Fame Super Silver

Re: unable to session into wireless controller on 3750G

Yeah... console into the 3750G WLC and configure that first. Once you have it on the network, then you can GUI and finish up the configuration unless you are familiar with the WLC CLI.

-Scott
*** Please rate helpful posts ***
New Member

Re: unable to session into wireless controller on 3750G

Thanks for the help!

1243
Views
0
Helpful
4
Replies